Reduction of heavy metal content in Hiroshima Bay oysters (Crassostrea gigas) by purification

Cultured oysters from Hiroshima Bay were analysed to determine the content of nine trace elements, cadmium (Cd), lead (Pb), chromium (Cr), arsenic (As), manganese (Mn), nickel (Ni), copper (Cu), zinc (Zn), and iron (Fe) and compared with oysters treated for 48 h in both artificial sea water and a solution of 0.5% ethylenediaminetetraacetic acid (EDTA) in artificial sea water. It was found that the values of As and Fe in both groups of treated oysters were significantly lower than in the untreated oysters and that the Pb and Mn levels tended to be lower. It was also found that oysters treated in 0.5% EDTA solution in artificial sea water had lower levels of Cd and Cu than the oysters treated only in artificial sea water.     

Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

Development of monitoring technology for airborne particulate matter

Particulate matter suspended in the air has adverse effects onhuman health. Its level of concentration is an important parameter in evaluating the degree of hazard it poses to the atmosphere. Conventional methods used in measuring particulatematter are often filter-based, which indicates some disadvantagesbecause such a base requires labor and time. In this study, to achieve real-time measurements, a new electrical method was developed for measuring PM10 and PM2.5 concentrations. The basicprinciple is to electrically charge particles passing through thePM inlet using a corona charger and measure the currents createdby charged particles to obtain the number concentration of particulate matter. A new type inlet based on the particle cupimpactor configuration was designed and its performance was evaluated. A unipolar diffusion charger was developed and thecharger's efficiency was determined experimentally in terms ofPn, which represents the penetration through the charger,P, times the average charge number acquired by a particle,n, for different particle sizes. The correlation was constructed between the PM10 (or the PM2.5) mass concentrationsand the electrical currents due to particles, which were chargedby the diffusion charger.     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

Suspended particulates and bioaerosols emitted from an agricultural non-point source

Suspended particulate and bioaerosol levels were measured at three sites downwind of an agricultural non-point source during the wheat harvesting season. Suspended particulates were detected at mean values ranging from 10000 to 2420 micrograms m-3 at distances of from 20 to 60 m downwind of the source, respectively. Airborne viable bacterial counts were recorded at mean values ranging between 10(4) and 10(6) colony forming units (cfu) m-3, whereas, Gram negative (Gram -ve) bacteria varied between 10(3) and 10(5) cfu m-3. Fungi levels were detected at mean values varying between 10(5) and 10(6) cfu m-3. However, streptomycetes were found at lower counts than those recorded for viable bacteria and fungi. Total viable bacteria, Gram -ve bacteria, fungi and streptomycetes associated hay fragments were determined at mean values of 1.5 x 10(6), 1.6 x 10(3), 2.2 x 10(4) and 6 x 10(3) cfu g-1 of hay, respectively. Cladosporium, white and red yeasts as well as Alternaria were the predominant airborne fungi, whereas, Alternaria was the dominant species associated with hay fragments. Pseudomonas, Acinetobacter and Enterobacteriaceae were the dominant Gram -ve bacteria. The most common fungal genera, such as Cladosporium and Fusarium (minor short axis), as well as Streptomyces species have an aerodynamic diameter (dae) of less than 5 microns, which can penetrate and deposit in the alveoli. Farmers and nearby residents are exposed to high levels of organic dust and bioaerosols during the wheat harvesting season. This may cause health problems in exposed persons based on toxic or allergic reactions.     

Speciation of arsenic using solid phase extraction cartridges

Various solid phase extraction (SPE) cartridges were investigated for speciation of arsenite [As(III)], arsenate [As(v)], monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA). Cartridges containing different types of sorbent materials were tested for arsenic retention and elution characteristics. Alumina cartridges were found to completely retain all the four target arsenic species, and are suitable for removal and preconcentration purposes. For speciation analysis, different arsenic species were separated on the basis of their selective retention on and elution from specific cartridges. DMA was retained on a resin-based strong cation exchange cartridge and eluted with 1.0 M HCl. MMA and As(v) were both retained on a silica-based strong anion exchange cartridge and sequentially eluted with 60 mM acetic acid (for MMA) and 1.0 M HCl [for As(v)]. As(III) was not retained on either cartridge and remained in solution. Arsenic species in solution and those eluted from the cartridges were subsequently quantified by using flow injection with hydride generation atomic fluorescence spectrometry (FI-HGAFS) and hydride generation atomic absorption spectrometry (FI-HGAAS). A detection limit of 0.05 microg L(-1) arsenic in water sample was achieved using HGAFS. An application of the method was demonstrated at a drinking water treatment facility. As(III) and As(v) species were determined in water at various stages of treatment. The method is suitable for routine determination of trace levels of arsenic in drinking water to comply with more stringent environmental regulations.     

Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).     

Control of rumen methanogenesis

During the last decades, considerable research on methane production in the rumen and its inhibition has been carried out. Initially, as methane production represents a significant loss of gross energy in the feed (2–15%), the ultimate goal of such intervention in rumen fermentation was an increase in feed efficiency. A second reason favouring research on methane inhibition is its role in the global warming phenomenon and in the destruction of the ozone layer. In this review, the authors describe briefly several interventions for reducing methane emission by ruminants. The objective can be reached by intervention at the dietary level by ration manipulation (composition, feeding level) or by the use of additives or supplements. Examples of additives are polyhalogenated compounds, ionophores and other antibiotics. Supplementation of the ration with lipids also lowered methanogenesis. More biotechnological interventions, e.g., defaunation, probiotics and introduction of reductive acetogenesis in the rumen, are also mentioned. It can be concluded that drastic inhibition of methane production is not unequivocally successful as a result of several factors, such as: instantaneous inhibition often followed by restoration of methanogenesis due to adaptation of the microbes or degradation of the additive, toxicity for the host animal, negative effects on overall digestion and productive performance. Therefore, methanogenesis and its inhibition cannot be considered as a separate part of rumen fermentation and its consequences on the animal should be taken into account.     

Floristics, performance and prognosis of historical trees in the urban forest of Guangzhou City (China)

Outstanding historical trees embedded in cities constitute pertinent environmental assets, yet they are widely threatened in third-world cities. Inadequate understanding of this valuable natural-cum-cultural heritage hinders proper conservation. A case study of Guangzhou in south China evaluated floristic composition, age profile and biomass structure of historical trees, assessed their performance in major habitats (institutional, park and roadside), and established a prognosis for future growth and management. The 348 historical trees examined belonged to only 25 species, vis-à -vis 254 trees in the entire urban forest, dominated by five species and native members. Roadside had more trees, followed by institutional and park, with merely the most common four species shared by all habitats. The limited commonality reflected tree-performance differentiation by habitats exerting selection pressure on species. The institutional growth-regime was more conducive to nurturing high-caliber specimens, whereas park is less capable. Individual species achievement by habitats, derived from tree-count ranking and relative-abundance indices, could inform species choice and tree conservation. Few trees exceeded 300 years of age in the millennium-old city, echoing a history of intense tree—city conflicts. Potential life-span, trunk and crown diameters indicated ample opportunities for further expansion of biomass and landscape impacts, which would be straitjacketed by the tightening urban fabric.     

Environmental and biological monitoring of methyl ethyl ketone (MEK)

This study was conducted to evaluate the usefulness of various biological parameters for monitoring of workers exposed to methyl ethyl ketone (MEK). Fifty male workers from a large magnetic videotape factory participated in this study. Personal air samples were collected using 3M organic vapor monitors and analysed for MEK by gas chromatography with flame ionisation detector (FID). 10 mL of urine; blood (1 mL) and exhaled air were also collected at the end of an 8-hour workshift. The headspace GC method was applied for measurement of urinary and blood MEK. MEK in expired air was analysed directly by using a GC/FID.The correlation coefficients (r) between environmental MEK and all other biological parameters measured show significant positive relationships. The r for environmental MEK and urine MEK was 0.84; for blood 0.73 and for breath 0.64. The correlation coefficients between blood and urine was 0.72; blood and breath was 0.88 and urine and breath 0.60. These findings suggest that measurements of unmetabolised MEK in blood, exhaled air and urine can be used for biological monitoring of MEK exposure. Nevertheless, laboratory methodological assessment is in favour of measuring urinary MEK as it is non-invasive and does not have to be analysed immediately after collection.